Toyota Highlander manuals

Toyota Highlander Service Manual: Starting & charging

Toyota Highlander Service Manual / Starting & charging

Crankshaft position sensor (3MZ-FE)
REPLACEMENT HINT: A bolt without a torque specification is shown in the standard bolt chart (see page 03-2 ). 1. REMOVE ENGINE UNDER COVER NO.1 (a) Remove the 6 screws, 2 clips and under cov ...

Starting system (2AZ-FE)
INSPECTION 1. INSPECT STARTER ASSY NOTICE: These tests must be performed within 3 to 5 seconds to avoid burning out the coil. (a) Do the pull-in test.  Disconnect the lead wire from ...

More about Toyota Highlander:

Inspection
1. INSPECT THERMOSTAT HINT: The thermostat is numbered with the valve opening temperature is stamped on the thermostat. (a) Immerse the thermostat in water and gradually heat the water. (b) Check the valve opening temperature. Valve opening temperature: 80 to 84 C (176 to 183 F) ...

В© 2011-2026 Copyright www.tohighlander.com