Toyota Highlander Service Manual: Drive shaft, propeller shaft, axle
PRECAUTION
1. NOTICE OF REMOVING AND INSTALLING FRONT DRIVE SHAFT ASSY RH
(a) When removing and installing the front drive shaft assy RH in a 4WD vehicle, be sure to first drain all the transaxle oil and transfer oil. If removal and installation is carried out without draining these oils, the transfer oil will flow into the transaxle side. Extensive cleaning will be required if the two oils mix.
Problem symptoms table
Use the table below to help determine the cause of the problem. The causes of
problem are listed
in order of probability in the "Suspected Area" column. Check each part in
order. If necessary, re ...
More about Toyota Highlander:
Transfer extension housing type T oil seal (4WD)
REPLACEMENT
1. REMOVE EXHAUST PIPE ASSY (3MZ-FE ENGINE TYPE) (SEE PAGE 15-5 )
2. REMOVE EXHAUST PIPE ASSY (2AZ-FE ENGINE TYPE) (SEE PAGE 15-2 )
3. REMOVE TRANSFER CASE NO.1 PLUG
4. REMOVE TRANSFER DRAIN PLUG
5. REMOVE PROPELLER W/CENTER BEARING SHAFT ASSY (SEE PAGE 30-12 )
6. REMOVE TRANSFER E ...
