Toyota Highlander Service Manual: Transfer
Toyota Highlander Service Manual / Transfer
- Transfer system (4WD)
- Transfer (4WD)
- Transfer oil (4WD)
- Transfer RH bearing retainer oil seal (4WD)
- Transfer case oil seal (4WD)
- Transfer extension housing type T oil seal (4WD)
- Transfer ASSY (4WD)
Rear axle LH hub bolt
REPLACEMENT
HINT:
COMPONENTS:SEE PAGE 30-4
Replace the RH side by the same procedures with the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSY LH
(2WD DRIVE TYPE)
(a) Rem ...
Transfer system (4WD)
PRECAUTION
Before disassembly, clean the transfer assy and remove any deposited
sand or mud to prevent
it from entering the inside of the transfer during disassembly and assembly.
When remo ...
More about Toyota Highlander:
Terminals of ECU
1. CHECK SLIDING ROOF DRIVE GEAR SUB- ASSY (SLIDING ROOF ECU)
(a) Disconnect the sliding roof ECU connector, and check the
voltage or continuity of each terminal of the wire harness
side connector.
If the result is not as specified, there may be a malfunction on
the wire harness. ...
В© 2011-2025 Copyright www.tohighlander.com
