Toyota Highlander Service Manual: Front differential oil seal (U241E)
REPLACEMENT
1. REMOVE FRONT WHEELS
2. REMOVE ENGINE UNDER COVER NO.1
3. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug, gasket and drain ATF.
(b) Install a new gasket and drain plug.
Torque: 49 NVm (500 kgfVcm, 36 ftVlbf)
4. REMOVE FRONT DRIVE SHAFT ASSY RH (SEE PAGE 30-21 )
5. REMOVE FRONT DRIVE SHAFT ASSY LH (SEE PAGE 30-21 )
6. REMOVE TRANSAXLE HOUSING OIL SEAL
(a) Using SST, pull out the oil seal.
SST 09308-00010
7. REMOVE DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL
(a) Using SST, pull out the oil seal.
SST 09308-00010
8. INSTALL TRANSAXLE HOUSING OIL SEAL
(a) Using SST and a hammer, drive in a new oil seal.
SST 09316-6001 1 (09316-00011)
Oil seal drive in depth: 0 0.5 mm (0 0.020 in.)
(b) Coat the lip of the oil seal with MP grease.
9. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEAL
(a) Using SST and a hammer, drive in a new oil seal.
SST 09649-17010, 09950-70010 (09951-07150)
Oil seal drive in depth: 0 0.5 mm (0 0.020 in.)
(b) Coat the lip of the oil seal with MP grease.
10. INSTALL FRONT DRIVE SHAFT ASSY LH (SEE PAGE 30-21 )
11. INSTALL FRONT DRIVE SHAFT ASSY RH (SEE PAGE 30-21 )
12. INSTALL FRONT WHEELS
Torque: 103 NVm (1,050 kgfVcm, 76 ftVlbf)
13. ADD AUTOMATIC TRANSAXLE FLUID
14. INSPECT AUTOMATIC TRANSAXLE FLUID (SEE PAGE 40-2 )
15. CHECK ABS SPEED SENSOR SIGNAL
Oil W/hose cooler ASSY (U151E/U151F)
REPLACEMENT
1. REMOVE FRONT BUMPER COVER (SEE PAGE 76-2 )
2. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug and gasket, and drain ATF.
(b) Install a new gasket and the drain plug.
To ...
Front differential oil seal (U140F)
REPLACEMENT
HINT:
When replacing the front differential oil seal (LH) or (RH), perform step 1 to
11 or 12 to 21 respectively.
1. REMOVE FRONT WHEELS
2. REMOVE ENGINE UNDER COVER NO.1
3. DRAIN A ...
More about Toyota Highlander:
When stopping the engine with the shift lever in a position other
than p
If the engine is stopped with the shift lever in a position other than p,
the engine switch will not be turned off but instead be turned to
accessory mode. Perform the following procedure to turn the
switch off:
Check that the parking brake is set.
Shift the shift lever to p.
Check that в ...
