The speed setting is also canceled when the brakes are applied.
Resuming is available when the vehicle speed is more than approximately 25 mph (40 km/h).
Cruise control can be set when
Accelerating after setting the vehicle speed
Automatic cruise control cancelation
Cruise control will stop maintaining the vehicle speed in any of the following situations.
At this time, the memorized set speed is not retained.
If the warning message for the cruise control is shown on the multIInformation display
Press the “on-off” button once to deactivate the system, and then press the button again to reactivate the system.
If the cruise control speed cannot be set or if the cruise control cancels immediately after being activated, there may be a malfunction in the cruise control system. Have the vehicle inspected by your toyota dealer.
![]()
Switch the cruise control off using the "on-off" button when not in use. Situations unsuitable for cruise control Do not use cruise control in any of the following situations. Doing so may result in loss of control and could cause an accident resulting in death or serious injury.
|
Front drive shaft
OVERHAUL
HINT:
COMPONENTS: SEE PAGE 30-4
Overhaul the RH side following the same procedures as for the LH side.
1. DRAIN AUTOMATIC TRANSAXLE FLUID (SEE PAGE 40-2 )
2. DRAIN TRANSFER OIL (4WD DRIVE TYPE) (SEE PAGE 31-9 )
HINT:
Perform the procedure only when removing the RH side.
3. REMOVE FR ...