REPLACEMENT
HINT:
1. REMOVE TONNEAU COVER ASSY (SEE PAGE 76-21 )
2. REMOVE DECK BOARD SUB-ASSY NO.2 (SEE PAGE 76-21 )
3. REMOVE DECK BOARD SUB-ASSY NO.3 (SEE PAGE 76-21 )
4. REMOVE DECK FLOOR BOX REAR (SEE PAGE 76-21 )
5. REMOVE DECK FLOOR BOX FRONT (SEE PAGE 76-21 )
6. REMOVE REAR FLOOR FINISH PLATE (SEE PAGE 76-21 )
7. REMOVE DECK SIDE TRIM BOX RH (SEE PAGE 76-21 )
8. REMOVE DECK TRIM SIDE PANEL ASSY RH (SEE PAGE 76-21 )
9. REMOVE STEREO COMPONENT AMPLIFIER ASSY
(a) Remove the 2 nuts and bolt.
(b) Disconnect the connectors, then remove the stereo component amplifier assy.
Crankshaft position sensor (3MZ-FE)
REPLACEMENT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (see
page 03-2 ).
1. REMOVE ENGINE UNDER COVER NO.1
(a) Remove the 6 screws, 2 clips and under cover.
2. REMOVE FRONT FENDER APRON SEAL RH
(a) Remove the clip, 2 bolts and apron seal.
3. REMO ...